Skip to first unread message
Sergey Afonin
May 6, 2014, 10:31:41 AM5/6/14
to kisslicer-r...@googlegroups.com
Dear friends,
I use RapMan 3.1DH. I started using Axon for slicing, changed to KS later. I use them now depending on work. I found Extruder Gear ratio field set to 1 in recommended config after year using KS . It is strange for me because extruder contains of gears 14:17. I set it to 0.85 and rolled back Tweak to 1. It works fine again.
What is your settings of Gear ratio if you use RapMan printer? What is the value you use?
Regards,
Sergey
I use RapMan 3.1DH. I started using Axon for slicing, changed to KS later. I use them now depending on work. I found Extruder Gear ratio field set to 1 in recommended config after year using KS . It is strange for me because extruder contains of gears 14:17. I set it to 0.85 and rolled back Tweak to 1. It works fine again.
What is your settings of Gear ratio if you use RapMan printer? What is the value you use?
Regards,
Sergey
Reply all
Reply to author
Forward
0 new messages