Cubex duo issue support: PLA model: ABS

[Joost Buiter]

Hi Guys, 

I'm running into a problem when i make a print with a PLA support and ABS model. the two materials really do not want to stick together that well.

 What happens is that the model often releases from the support layer/raft before the print is ready, which makes multimaterial prints unusable. 

Is there anything i can do to make the two materials stick together a little bit better? 

[Ryan]

I haven't tried this yet, but you could build the model & supports using ABS & do a PLA interface.  That is at least what I am going to try.

[Joost Buiter]

I also tried that, but the fact that the ABS model releases from the PLA rafter is not solved by that right?