You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to kisslicer-r...@googlegroups.com
I was wondering if someone can help me to adjust the fan setting for my cubex using kisslicer and cubeitmodv4,5, I have printed the same item 3 times and it is lifting in the same corner right where the fan is constantly on. I have it set at the default of 100, is this something I need to change or does it have to be set at that. Thank you I am still learning.
hugues
unread,
Aug 27, 2014, 4:20:22 PM8/27/14
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to kisslicer-r...@googlegroups.com
Try the function Fan Z with few mm in the value. You you print with a raft or a brim to increase adherence ?