You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to kisslicer-r...@googlegroups.com
Dead friends,
I use RapMan 3.1. Dual Head. I never had success in printing two materials in one model. The issue is time and matrial consumption. I guess it is connected to slicer settings. Printer heat up exptruder from warm to working temperature and does material purge before printing new material on each layer. It takes a few minutes to heat and some portion of material to purge. I have extra hours and meters of filament for printing in two materials. Action sequence for example: - heat extruder one; - purge extruder one; - print by extruder one; - cool extruder one to warm temp; - heat extruder two; - purge extruder two; - print by extruder two; - change layer; - cool extruder two to warm temp; ...... and again from beginning...
instead of (when printing in one material) - heat extruder one; - purge extruder one; - print by extruder one; - change layer; ........ no full loop, print and change layer only; - cool extruder one;