You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to kisslicer-r...@googlegroups.com
Anyone know how to calibrate the estimated print time?
frozen...@yahoo.com
unread,
Feb 9, 2014, 7:37:30 AM2/9/14
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to kisslicer-r...@googlegroups.com
Best way I have found is to run a print to get the real time, then go back to KS and slice again and adjust XY Accel under Printer>Speed until the time estimate matches. I had asked this on the KS forum, and was informed that XY Accel only affects the time estimate, not the gcode.