Midea Ac Unit Manual

[Alexandrin Chaples]

Remotesignal-receiving function

There is the signal receiver for the wireless remote controller on the KJR-29B. You can use the wireless remote controller to control the air-conditioner through the wired remote controller when the system has been powered on.

Notes: The wired controller will not receive the swing controlling instruction. For the indoor unit with swinging function, you can directly use the remote controller to control swinging through the display panel of the indoor unit, or use the swing button on the wired remote controller to control the indoor unit for swinging.

ON/OFF Button

Press the ON/OFF button to control the indoor unit on and off status. When the unit is turned off, press the ON/OFF button, the unit will be turned on and the operating icon lights up. When the unit is turned on, press the ON/OFF button, the unit will be turned off and the operating icon lights off.

Clock setting

Long press the timer/clock setting button for 3 seconds, and then enter into the clock setting status. The hour position of the clock will flash, and can press Temp setting buttons to adjust the hour value. After finish the hour setting, press left button or right button to switch to minute position setting, then the minute position will flash, press Temp setting buttons to adjust the minute value. After finish the clock setting, press the button or wait for 5seconds to confirm and exit the setting state.

Wired controller locking

Press the temperature adjusting UP and DOWN buttons simultaneously, the wired controller enters into locking state, and the locking icon will be lighted up. Under the locking state, the wired controller will not respond to buttons by pressing and the control instruction from the wireless remote controller. Simultaneously press temperature adjusting buttons again can cancel the locking state.

Air filter cleaning reminding function

The wired controller records the total running time of the indoor unit, when the accumulated running time reaches the pre-set value, air filter cleaning reminding icon will be lighted up, to remind that the air filter of the indoor unit needs to be cleaned. Long press left button for 3 seconds, and clear the reminding icon and the wired controller will re-accumulate the total running time of the indoor unit.

Notes: The default setting value of reminding function is 2500 hours, and it can change to be 1250 hours, 5000 hours or 10000 hours. The setting methods please refer to the installation manual.

Swing Function

If the indoor unit supports swing function, press the right button to adjust the air outlet direction of the indoor unit. Long press this button for 3 seconds can turn on or turn off the auto-swing function. When the auto-swing Control system function is turned on, the swing icon will be lighted up.

When the system is running and the operating mode is AUTO. COOL or HEAT, press the left button will activate the Follow Me function. Press left button again will cancel follow me function. When the operating mode is changed, and then will cancel this function as well. When the Follow Me function is activated, the icon will be light up, and the wired controller will display room temperature read from the local sensor, and transmit the temperature value to the indoor unit every 3 minutes.

Connect two terminals of embedded 4-core shielding wire with the switching wires of wired remote controller and signal receiving board. Make sure the sequence of 4 terminals (A/B/C/D) should correspond to the wire sequence of signal switching wires (A/B/C/D).

Avoid water enters into the wired controller, use trap and putty to seal the connectors of wires during wiring installation. When under installation, reserve a certain length of the connecting wire for convenient to take down the wired controller while during maintenance.

shipping cost for all items only can be delivered to an empty ground floor room, or main apartment building entrance, provided social distancing requirements are adhered to by all parties. Please note that standard delivery does NOT include climbing up stairs, steps, or decks that are more than one. This job may impose extra fees, and the amount depends on the number of stairs.

Courier deliveries: Our courier partners delivering orders are currently experiencing very high volumes and long delivery delays throughout New Zealand, with destinations in Auckland.

Note: Couriers and transport companies are experiencing extremely high volume recently, and there might be delays for up to 10 days at the moment. Please keep patient, and carriers will deliver your products as soon as they could.

Click and collect is now available from our store located at 1/18 Link Drive, Wairau Valley, Auckland. You could choose "pick up" at check out and we will send you an email notification once your order is ready to be collected. Please only come once you have received the notification. Please ensure you have a proper vehicle to load all your items prior to come to collect your purchase.

When accepting delivery or picking up the items, please ensure you inspect the unit carefully and make sure you are completely satisfied with the items (ie no damages, no dents etc) BEFORE you accept the delivery (ie, sign the doc, let the delivery driver go, or leave the collection point). Failing to do so may limit your right to claim such damages after you have accepted the goods.

In terms 7-day right of return and exchange policy, customers can return or exchange store-wide products within 7 days after purchasing. The products should be returned unused, in its original condition with packaging, accessories and not affected for re-sell. In terms over 7-days, returns will be charge 20% restocking fees. This only applies for Midea Home Interior Centre and Midea North Shore Online Shop (www.mideahomes.co.nz) with the sole discretion of Midea Appliances

WARNING

PERSONAL INJURY, DEATH AND / OR PROPERTY DAMAGE HAZARD

Failure to follow this warning could result in personal injury, death or property damage.

Improper installation, adjustment, alteration, service, maintenance, or use can cause explosion, fire, electrical shock, or other conditions which may cause personal injury or property damage. Consult a qualified installer, service agency, or your distributor or branch for information or assistance. The qualified installer or service agency must use factory-authorized kits or accessories when modifying this product.

Read and follow all instructions and warnings, including labels shipped with or attached to unit before operating your new air conditioner.

REMOTE CONTROLCAUTION

EQUIPMENT DAMAGE HAZARD

Failure to follow this caution may result in equipment damage. Handle the control with care and avoid getting the control wet.

IMPORTANT: The remote control can operate the unit from a distance of up to 26 ft. (8 m) as long as there are no obstructions. When the timer function is used, the remote control should be kept in the vicinity of the fan coil (within 26 ft. / 8 m).

The remote control can perform the following basic functions:

@manualsplus YouTubeManuals+,Privacy PolicyThis website is an independent publication and is neither affiliated with nor endorsed by any of the trademark owners. The "Bluetooth" word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. The "Wi-Fi" word mark and logos are registered trademarks owned by the Wi-Fi Alliance. Any use of these marks on this website does not imply any affiliation with or endorsement.

To prevent injury to the user or other people and property damage, the instructions shown here must be followed. Incorrect operation due to ignoring of instructions may cause harm or damage. The level of risk is shown by the following indications. WARNING CAUTION NOTICEThis symbol indicates a hazardous situation which, if not avoided, could result in death or serious injury.This symbol indicates a hazardous situation, which, if not avoided, could result in minor or moderate injury.This symbol addresses practices not related to physical injury. WARNINGPlug in power cord plug properly.Otherwise, it may cause electric shock or fire due to excess heat generation.Do not modify power cord length or share the outlet with other appliances as itmay cause electric shock or fire due to overheating.Always ensure effective grounding.Incorrect grounding may cause electric shock.Unplug the unit if you notice unusual sounds or smells, or smoke comes from it.A damaged product may cause fire and electric shock.Keep firearms away from the unit.Ventilate room before operating the air conditioner if there is a gas leakage from another appliance.Do not operate or stop the unit by inserting or pulling out the power cord plug.Do not operate with wet hands or in very humid enviroments.It may cause electric shock.Do not allow water to come into contact with any electric parts.It may cause failure or electric shock.Do not use the socket if it is loose or damaged.It may cause fire and electric shock.Do not place the power cord close to heating appliances.It may cause fire and electric shockDo not disassemble or modify unit.It may cause failure and electric shock. WARNINGDo not disassemble or modify unit.It may cause failure and electric shock.Do not damage or use an alternate power cord.It may cause fire and electric shock.If the power cord is damaged, it must be replaced by the manufacturer or an authorized service center or a similarly qualified person in order to avoid a hazard.Do not direct airflow straight into persons to avoid possible health hazard.Do not open the unit during operation.It may cause electric shock.Do not use the power cord near flammable gas or combustibles, such as gasoline, benzene, thinner, etc.It may cause an explosion or fire.Do not let children hang on the air conditioner or bracket. A serious injury may occur.Avoid fire hazard or electric shock. Do not use an extension cord or an adaptor plug.Do not remove any prongs from the power cord.Be sure the air conditioner is properly grounded. To minimize shock and fire hazards, proper grounding is important. The power cord is equipped with a three- prong grounding plug for protection against shock hazards.Your air conditioner must be used in a properly grounded wall receptacle. If the wall receptacle you intend to use is not adequately grounded or protected by a time delay fuse or circuit breaker, have a qualified electrician install the proper receptacle. Ensure the receptacle is accessible after the unit installation.Be sure the electrical service is adequate for the model you have chosen. This information can be found on the serial plate, which is located on the side of the cabinet and behind the grille.Do not drink water drained from the air conditioner. CAUTIONWhen the air filter is to be removed, do not touch the metal parts of the unit.It may cause injury.When the unit needs cleaning, switch off, and turn off the circuit breaker.Do not clean unit when power is on as it may cause fire, electric shock or injury.Do not place obstacles around air inlets or inside of air outlet.It may cause failure or accident.Clean with a soft cloth only. Do not use strong detergents that contain wax or thinners as it may damage the product.Use caution when unpacking and installing. Sharp edges could cause injury.Do not clean the air conditioner with water.Water may enter the unit and degrade the insulation which could lead to electric shock. CAUTIONDo not put a pet or house plant where it will be exposed to direct air flow.This could injure the pet or harm the plant.Hold the plug by the head of the power plug when taking it out.Otherwise, it may cause electric shock and damage.Ensure that the installation is properly secured to prevent the product from potentially falling.Do not place heavy objects on the power cord and ensure that the cord is not compressed.Otherwise, there is danger of fire or electric shock.If water is spilled on the unit, turn off the unit and switch off the circuit breaker.Isolate supply by taking the power-plug out and contact a qualified service technician.Do not use near gas stove or other gas burning appliances, as air flow may affect gas combustion.Do not use for any purpose other than room comfort.Do not use this air conditioner to preserve precision devices, food, pets, plants, and art objects. It may cause deterioration.Turn off the main power switch if the unit is not to be used for an extended time.Always insert the filters securely. Clean filter once every two weeks.Operation without filters may cause failure.

3a8082e126