Clipart and Instructional Images

[Julian Russbach]

Ive created some basic images of reeds and pipes (attached). I can create specific images on request for the handbook or instructional use. If you need any clipart as such, let me know and I will do my best to create it. Thank you.

[Dimitar Vassilev]

2013/6/17 Julian Russbach via Kaba Gaida <kabagaida+noreply-APn2wQcIu5vJnv...@googlegroups.com>

Ive created some basic images of reeds and pipes (attached). I can create specific images on request for the handbook or instructional use. If you need any clipart as such, let me know and I will do my best to create it. Thank you.

--
You received this message because you are subscribed to the Google Groups "Kaba Gaida" group.
To unsubscribe from this group and stop receiving emails from it, send an email to kabagaida+...@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.
 
 

Hi Julian,
2nd image is wrong at least for my perception. You're putting the reed into the tinier end. It should be reverse.
Cheers,

[Julian Russbach]

What about the image lends it to the smaller end? The flattened notch on the drone is on the side with the reed. The hole the reed is going into is larger than the reed itself. The smaller end of the drone would have a hole smaller than the diameter of the reed.

On Monday, June 17, 2013 12:48:35 AM UTC-5, Див Бушмен wrote:

[Dimitar Vassilev]

Hi Julian,

you're right. However the semi-shades applied on your image for the drone pipe may confuse someone. Attached is how mine looks. Seems i don't have a flattened notch and you can increase the top part a bit to help the new guys spare some reeds.

Cheers,

Dimitar

2013/6/17 Julian Russbach via Kaba Gaida <kabagaida+noreply-APn2wQcIu5vJnv...@googlegroups.com>

[Цветелин Андреев]

The drone is round and doesn't matter how you put the reed into it (if it is made well). I can't see the point of the picture.

However the book is almost ready (the bulgarian version) and will need some drawings :)

Cvetelin Andreev
+359 889 651 656 

http://www.kabagaida.com 

[Julian Russbach]

Both my djura gaida and kaba gaida have a flattened notch on the drone. They were bothmade by different masters. I was told that this notch is to help identify the intended position of the reed. I struggled getting the sound of the drone correct until I adjusted the reed to be perpendicular and facing left of the notch. Maybe the gaidas I have are of lesser quality, but what I was told seems to be consistent with what works in practice. If there is a tendency for the notch to be used by some gaida makers, it might be worth noting to new players, so they don't struggle with it.