hi .. i have just finished to assemble my kit , i brought the pre-
assembled one
took an hour or so to build and setup , didn't have any problem in the
building process
at start-up the bootloader showed FW:06208.100 , then i plugged in my
bk precision 2mhz function generator
and played a bit with the DSO to test different waveform.
i have a question about it...
does the picOClock , component tester (huntron,lissajou style) ,
pong , text ,Four Channel Oscilloscope Adapter, scope artist) they all
mean't to be used with a CRT Scope
could work , some use y-channel with ext trigger, some need the 2
channel
'forgot to tell , yesterday it loosed it's fonction , after a few hour
later i found that the tl5510 had a cold solder on a pin , now it's
fix
and to finish i updated the new firmware 06208.101 , i used a simple
serial avr programmer with ponyprog2000 found at this site
http://electronics-diy.com/avr_programmer.php
and to transfer screenshot with jyeshot i use a max232 found here
http://jye-tech-oscilloscopes.googlegroups.com/web/MAX232+RS-232+interface.pdf
it work all the time