just bought, build and tested this:
LCD oscilloscope kit
model: 06204KP
Bootloader: 113-06202-026
FW: 06208.102
the scope work very well, good!
I have some suggestions for a firmware update:
1) When on HOLD, it is impossible to select SEC/DIV and change the time
base. This cause trouble mostly when the trigger is in SINGLE mode and
signal continually cause trigger event, because it is impossible to
change the timebase.
2) With the internal square wave, setting the timebase to 0.5 us, 1 us
and 2 us, the trigger event time position is out (before) the memory
window, i.e. moving H.POS all to the left, does not show the event, in
both SLOPE settings.
3) miss a bottom indicator that show the trigger time position
4) the trigger event should be default in the middle of memory window,
but as now seems it is more near the start of memory window (all to the
left), often outside of shown part. So it is necessary use often H.POS
to show the trigger event.
Hope in a firmware update to fix those little troubles.
thank you,
Valerio