[junoscriptorium] New script: library/juniper/op/interfaces/tunnel
Phil Shafer
phil.shafer has committed a new file to the junoscriptorium repository.
Please take a look, comment, and enjoy!
http://junoscriptorium.googlecode.com/svn/trunk/library/juniper/op/interfaces/tunnel/tunnel.xml
This script uses the wizard framework to get the configuration for
a tunnel. The tunnel is then configured on both end points.
The IPSEC side isn't done (at all) but will follow the same flow.
What else is needed?
I check that the endpoint address as already configured (requiring
a direct or loopback route to that address), but should I allow
aliases or duplicate paths? If the interface fe-0/2/0 on "rdu" is
"10.5.16.2", will folks use this address of make a second one on
the same interface?
The "Link Prefix" is at a /24 to /31 with the local side given and
the remote side one higher (so 10.11.22.1/30 becomes 10.11.22.2/30
on the remote box).
Enjoy,
The JUNOScriptorium Community (via add-file)