confirm that .X3G cannot control fan via PWM

[Firefly]

Hi,

I know this is an old subject, but I am asking to see if anything changed.

will .X3G never be able to control fan using PWM?

isn't there is other PWM controls such as the hotends? , which brings,  can any other controls be used for the fan?  second Hotend? .

And the RGB light . . .  I read it only has two on/off wires going to it? wow that doesn't make sense to me, I mean I can tell it to go to any color of the rainbow through this some software, I think it was makerbot desktop, I don't use it anymore.

Maybe the newer hardware can do more?  or maybe their "closed source" software is making it happen.

I don't understand the .X3G controls, but I do on some hardware logic, If you can utilize the two on/off control from light, I could make an arduino circuit to drive the fan at 4 different speeds.

I am just trying to exploit the possibility, I don't mean to beat a dead horse.

[Support]

##- Please type your reply above this line -##

Hello Jetty-firmware,

We'd love to hear what you think of our customer service. Please take a moment to answer one simple question by clicking either link below:

How would you rate the support you received?

Good, I'm satisfied

Bad, I'm unsatisfied

Here's a reminder of what this request was about:

Jetty-firmware Jan 3, 10:00 AM EST

-- You received this message because you are subscribed to the Google Groups "Jetty Firmware" group. To unsubscribe from this group and stop receiving emails from it, send an email to jetty-firmwar...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.

This email is a service from G3D. Delivered by Zendesk

[VXX0Q6-LRLL]