System Type X64-based Pc

0 views

Skip to first unread message

Hermila Farquhar

unread,

Aug 4, 2024, 2:21:37 PM8/4/24

to iramlida

Ijust received my first Arduino (2560 MEGA) and cannot seem to get the drivers functioning. When I plug the device in via USB, Windows 7 says it cannot find the drivers specified (ok). I go to Device Manager, right click the unknown device, Update Driver... From there I go to manual selection (automatic did not work) and point to Arduino 1.0 \ drivers \ Arduino MEGA 2560.inf and it says "The folder specified doesn't contain a compatible software driver for your device. if the folder contains a driver, make sure it is designed to work with your Windows for x64-based system." The Windows installation is pretty fresh, and I've performed all updates.

Any suggestions on this issue? I've read through what I believe are all the related forums posts here where ultimately the driver selection turns out to be the .INF file I chose above. Like the other user I was able to get it to recognize a driver (unable to replicate), place it under COM3 in "Ports (COM & LPT) in the Device Manager. Please see the attached screenshot.

Every time i try to set the *inf i get the massage

"The folder you specified soesn't contain a compatible software driver for your device. If the folder contain a driver, make sure it is designed to work with Windows for x64-based systems."

In computer architecture, 64-bit integers, memory addresses, or other data units[a] are those that are 64 bits wide. Also, 64-bit central processing units (CPU) and arithmetic logic units (ALU) are those that are based on processor registers, address buses, or data buses of that size. A computer that uses such a processor is a 64-bit computer.

From the software perspective, 64-bit computing means the use of machine code with 64-bit virtual memory addresses. However, not all 64-bit instruction sets support full 64-bit virtual memory addresses; x86-64 and AArch64 for example, support only 48 bits of virtual address, with the remaining 16 bits of the virtual address required to be all zeros (000...) or all ones (111...), and several 64-bit instruction sets support fewer than 64 bits of physical memory address.

The term 64-bit also describes a generation of computers in which 64-bit processors are the norm. 64 bits is a word size that defines certain classes of computer architecture, buses, memory, and CPUs and, by extension, the software that runs on them. 64-bit CPUs have been used in supercomputers since the 1970s (Cray-1, 1975) and in reduced instruction set computers (RISC) based workstations and servers since the early 1990s. In 2003, 64-bit CPUs were introduced to the mainstream PC market in the form of x86-64 processors and the PowerPC G5.

With no further qualification, a 64-bit computer architecture generally has integer and addressing registers that are 64 bits wide, allowing direct support for 64-bit data types and addresses. However, a CPU might have external data buses or address buses with different sizes from the registers, even larger (the 32-bit Pentium had a 64-bit data bus, for instance).[1]

Most high performance 32-bit and 64-bit processors (some notable exceptions are older or embedded ARM architecture (ARM) and 32-bit MIPS architecture (MIPS) CPUs) have integrated floating point hardware, which is often, but not always, based on 64-bit units of data. For example, although the x86/x87 architecture has instructions able to load and store 64-bit (and 32-bit) floating-point values in memory, the internal floating-point data and register format is 80 bits wide, while the general-purpose registers are 32 bits wide. In contrast, the 64-bit Alpha family uses a 64-bit floating-point data and register format, and 64-bit integer registers.

Many computer instruction sets are designed so that a single integer register can store the memory address to any location in the computer's physical or virtual memory. Therefore, the total number of addresses to memory is often determined by the width of these registers. The IBM System/360 of the 1960s was an early 32-bit computer; it had 32-bit integer registers, although it only used the low order 24 bits of a word for addresses, resulting in a 16 MiB (16 10242 bytes) address space. 32-bit superminicomputers, such as the DEC VAX, became common in the 1970s, and 32-bit microprocessors, such as the Motorola 68000 family and the 32-bit members of the x86 family starting with the Intel 80386, appeared in the mid-1980s, making 32 bits something of a de facto consensus as a convenient register size.

A 32-bit address register meant that 232 addresses, or 4 GB of random-access memory (RAM), could be referenced. When these architectures were devised, 4 GB of memory was so far beyond the typical amounts (4 MiB) in installations, that this was considered to be enough headroom for addressing. 4.29 billion addresses were considered an appropriate size to work with for another important reason: 4.29 billion integers are enough to assign unique references to most entities in applications like databases.

Some supercomputer architectures of the 1970s and 1980s, such as the Cray-1,[2] used registers up to 64 bits wide, and supported 64-bit integer arithmetic, although they did not support 64-bit addressing. In the mid-1980s, Intel i860[3] development began culminating in a 1989 release; the i860 had 32-bit integer registers and 32-bit addressing, so it was not a fully 64-bit processor, although its graphics unit supported 64-bit integer arithmetic.[4] However, 32 bits remained the norm until the early 1990s, when the continual reductions in the cost of memory led to installations with amounts of RAM approaching 4 GB, and the use of virtual memory spaces exceeding the 4 GB ceiling became desirable for handling certain types of problems. In response, MIPS and DEC developed 64-bit microprocessor architectures, initially for high-end workstation and server machines. By the mid-1990s, HAL Computer Systems, Sun Microsystems, IBM, Silicon Graphics, and Hewlett-Packard had developed 64-bit architectures for their workstation and server systems. A notable exception to this trend were mainframes from IBM, which then used 32-bit data and 31-bit address sizes; the IBM mainframes did not include 64-bit processors until 2000. During the 1990s, several low-cost 64-bit microprocessors were used in consumer electronics and embedded applications. Notably, the Nintendo 64[5] and the PlayStation 2 had 64-bit microprocessors before their introduction in personal computers. High-end printers, network equipment, and industrial computers, also used 64-bit microprocessors, such as the Quantum Effect Devices R5000.[citation needed] 64-bit computing started to trickle down to the personal computer desktop from 2003 onward, when some models in Apple's Macintosh lines switched to PowerPC 970 processors (termed G5 by Apple), and Advanced Micro Devices (AMD) released its first 64-bit x86-64 processor. Physical memory eventually caught up with 32 bit limits. In 2023, laptop computers were commonly equipped with 16GB and servers up to 64 GB of memory, greatly exceeding the 4 GB address capacity of 32 bits.

The x86-64 architecture (as of 2016[update]) allows 48 bits for virtual memory and, for any given processor, up to 52 bits for physical memory.[26][27] These limits allow memory sizes of 256 TB (256 10244 bytes) and 4 PB (4 10245 bytes), respectively. A PC cannot currently contain 4 petabytes of memory (due to the physical size of the memory chips), but AMD envisioned large servers, shared memory clusters, and other uses of physical address space that might approach this in the foreseeable future. Thus the 52-bit physical address provides ample room for expansion while not incurring the cost of implementing full 64-bit physical addresses. Similarly, the 48-bit virtual address space was designed to provide 65,536 (216) times the 32-bit limit of 4 GB (4 10243 bytes), allowing room for later expansion and incurring no overhead of translating full 64-bit addresses.

The Power ISA v3.0 allows 64 bits for an effective address, mapped to a segmented address with between 65 and 78 bits allowed, for virtual memory, and, for any given processor, up to 60 bits for physical memory.[28]

A change from a 32-bit to a 64-bit architecture is a fundamental alteration, as most operating systems must be extensively modified to take advantage of the new architecture, because that software has to manage the actual memory addressing hardware.[31] Other software must also be ported to use the new abilities; older 32-bit software may be supported either by virtue of the 64-bit instruction set being a superset of the 32-bit instruction set, so that processors that support the 64-bit instruction set can also run code for the 32-bit instruction set, or through software emulation, or by the actual implementation of a 32-bit processor core within the 64-bit processor, as with some Itanium processors from Intel, which included an IA-32 processor core to run 32-bit x86 applications. The operating systems for those 64-bit architectures generally support both 32-bit and 64-bit applications.[32]