Encounter CE router Conformance tool testing for router

[aditya kumar]

Hello Sir/Mam,

I am trying to use Conformance tool for our router testing but found the tool is not fully automated and in addition to that if router is sending packets bit early/delay the test tool doesn't recognize further any of the test cases.

I have a doubt in DHCP WAN cases :-

1.Once router successfully gets IP after that if router receives RA (M =1) ,does router need to send again solicit request ?

The reason I am asking is ,for every case of dhcp sends RA .

2.Lets take LAN lanrfc3736 .

 why does tool send RA rather than solicit request ?Here is the snap shot (LAN_DHCP).

3.Even though I set all parameters =1 of config.pl then also getting"This test is not supported by NUT ".

Can somebody advise me to resolve this problem ?

4.For WAN RFC 3633 – Request Router,

scripts 1-15 says "This test does not support Host".However I configured Type router.

Could you advise me to overcome above problems.

Can somebody suggest the good group names where I can join and discuss on ipv6 testing tool and ipv6 topic particularly,

Regards,

Aditya

[aditya kumar]

Dear All,

Does anybody share his/her experience on CE router tool on above questions ?

Thanks in advance.

Regard,

Aditya