Problem with servo for the waist

[Fighting For Freedom]

Hello,

I’m assembling the waist with 2 JX 2070 servo’s (that’s an upgrade of the JX 2060 and act similar with the same degree), and I allready broke 2 pots. I don’t understand because the pot reacts well (going forward and backwards) I also done the wiring correct (one servo reversed wiring for the waist). But as soon I place the pot in the socket it turns only one direction and way too far. What I’m doing wrong? 

Regards Marina

[gael langevin]

Hello, 

You need to invert the two power cables (Vcc and Gnd) connected on your potentiometer. 

Keep the middle cable the same. (Signal)

Gael Langevin

Creator of InMoov

InMoov Robot

@inmoov

--
You received this message because you are subscribed to the Google Groups "InMoov" group.
To unsubscribe from this group and stop receiving emails from it, send an email to inmoov+un...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/inmoov/c3d89ac8-420f-4d7f-9913-e05dcdc127e9n%40googlegroups.com.