MRL 1.0.107 does not recognize arduino mega 2560

106 views
Skip to first unread message

Thanos Imac

unread,
Jul 5, 2016, 2:55:01 PM7/5/16
to InMoov

Hello!

I am using MRL 1.0.107 as recommended and I have some problem with my arduino!!!
MRL 1.0.107 does not recognize my arduino mega 2560!!

Can somebody help me!

Thank You!


img1.png
img2.png
img3.png
img4.png
img5.png
img6.png

Kevin Watters

unread,
Jul 5, 2016, 5:42:15 PM7/5/16
to InMoov
My guess is you're using 32 bit java on a 64 bit operating system, so the wrong dependencies got downloaded.  (that's just my guess)
Make sure, that you are using 64 bit java if your operating system is 64 bit.  Once you make sure of that, re-download and install the services.  (it's very important that the architecture is correct when you download, o/w the wrong dependencies will be installed..)

Thanos Imac

unread,
Jul 6, 2016, 10:34:19 AM7/6/16
to InMoov
I checked again every thing and I noticed that my arduino is recognized by a newer version of mrl!!

-BUT,there is an error with webgui service and to make it work i need to delete the lines with webgui! Doing that i have no voice control! (but i have manual movement of the hand) Also i am using the imoov3 script with this version of mrl with inmoov2 script on the newest version of mrl does not have voice control as well !!

Pedro Rego

unread,
Jul 6, 2016, 11:16:38 AM7/6/16
to InMoov
hello thanks!!!

putting MRL working is a bit confusing, this is what i can advice you, start all again

1-download lateste version, MRL webpage where it says top left "latestbuild" its the 1.0.1412 DO NOT GO TO DOWNLOADS
2- put it on a directory
3- CMD java -jar my.robotlab
4-Install all and reboot
5-run a the inmoov.minimal3 (can be tthe finger also)
6-check if you have chrome as default otherwise wont work
7- if anything go wrong tell me ill help
Reply all
Reply to author
Forward
0 new messages