New neck

[Fighting For Freedom]

Hello,

The 2 servos in the back of the nek have to be prepared the same as the servos in the top stomach, right?  Because I read somewhere that you don’t have to remove the pin of the gear on the master servo, only the pin on the slave servo (the non-moterized, without the PCB board and potentiometer). Is that true? I removed all pins of the gears from all the servo’s for the mid stomach and top stomach.

And for this tilt Motion I don’t have to change the polarity of the cables, just using the same colors. Is that correct?

And for the front neck Servo I removed the pin of the gear and the intern pot same as the bicep servo, also without changing the polarity of the pot?

Regards, Marina

[gael langevin]

Correct: The 2 servos in the back of the nek have to be prepared the same as the servos in the top stomach

True:  you don’t have to remove the pin of the gear on the master servo, only the pin on the slave servo

Correct: And for this tilt Motion I don’t have to change the polarity of the cables, just using the same colors

Correct:  for the front neck Servo I removed the pin of the gear and the intern pot same as the bicep servo, also without changing the polarity of the pot

Gael Langevin

Creator of InMoov

InMoov Robot

@inmoov

--
You received this message because you are subscribed to the Google Groups "InMoov" group.
To unsubscribe from this group and stop receiving emails from it, send an email to inmoov+un...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/inmoov/f01c3ef6-6754-4152-aee3-9efcc0b4a26dn%40googlegroups.com.