SideRibsCoverV2 right and left - printing issues?

[MAURICE GLYNNE]

Has anyone else had problems printing these?

I have tried printing at 0.2 and 0.3mm layer height

Problem is with one of the two stubs with  built in supports on both pieces.

The "good" one goes from top to bottom: support1 ; stub1; support2; stub2.

The "bad" one goes: support1: stub1: gap: support2 ; stub2.

The 'gap' is so high that support2 does not stick, so it spaghetti's for the rest of the print.

Not good.

Anyone know a way around this?

Thanks

Maurice ( a newbie)

 

[MAURICE GLYNNE]

FYI

I'm slicing with Cura 4.11.0

I have printed two hands, biceps, shoulders , plus torso and chest,
without any other problems.

[gael langevin]

Hello,

I edited the file to check if I had left something aside, but didn't find anything wrong.

Here below are the stl without the built in support, you will need to ask cura to create the support.

Gael Langevin

Creator of InMoov

InMoov Robot

@inmoov

--
You received this message because you are subscribed to the Google Groups "InMoov" group.
To unsubscribe from this group and stop receiving emails from it, send an email to inmoov+un...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/inmoov/09e5465d-7f45-498b-9ab6-ff09ec0f2cbbn%40googlegroups.com.

[MAURICE GLYNNE]

Gael,

Many thanks for that and a really great job on Inmoov, and your instructions

(Once I translated 'weld' to mean 'solder' and 'tab' to mean 'tap'!).

Am I the oldest builder @ 74?

Maurice

[James Kelly]

Maurice,

I'm right behind you at age 73

Jim (Houston TX)