hydro control

The 3 phase induction motor as generator IMAG has - a minimum capacitance to start self-excitation,

Q: I need to connect a generator (20KW) of permanent magnets in on grid mode to the 220vac / 50hz

4 basic components needed: - turbine - induction motor as generator - capacitors - IGC induction

Question: Would you recommend a 3x50% or two x 100% dump load setup for redundancy? That is a good

Aeg Electrolux Kuppers Ofen Haube Backofen Heizelement 3871425108 https://www.amazon.de/Electrolux-

https://www.hs-dynamics.com/ from China https://www.micro-hydro-power.com/

See https://sites.google.com/site/hydrocontrolwiki/simple-vs-extended-version Please leave your

http://outbackpower.com/outback-products/make-the-power/fxr-series-inverter-chargers Operate the unit

Induction generator (induction motor as generator IMAG) Pros - cheaper than synchronous generator -

Advantages: Cheaper than custom made turbines Disadvantages: No water jet adjustments possible,

I have good experiences with the following generator manufacturers, who build synchronous generators

Question: The available water flow varies greatly. A spear valve needs to be adjusted according to

An average estimation would be 1500 - 3000 USD/kW capacity. Microhydro systems smaller than 100 kW

i would like to build ELC for upto 5kw. i would be very thankful if you help me in circuit diagram,

If bearings get wet, they will only survive for a few months. Depending on how small you make the

Wiring: (picture taken from the first link below) Capacity of C2 is double that of C1, hence the

This wiring works for fixed flow valves. That is, the valve shall be either completely open or

Before you give the ELC control over your system, the basic settings should be correct. Some

You can find a price list on the products page. I'd like to hear you opion whether the prices are

You can find a price list now on the product page.