sipura-3000 adapter pitanja
Roki
Zanima me kupnja sipura-3000 adaptera, nasao sam ovdje samo:
http://www.solaterm.hr/content.asp?contentid=164
Ima li jos gdje na ponudi takav ATA adapter?
Takodjer htio bih provjeriti dva detalja prije kupnje kod iskusnijih:
- Ako u Sipra 3000 ukljucim standardni fax uredjaj i kako moj VOIP provider
podrzava T.38 i G.711 codece (
http://www.gafachi.com/d/1212995/Sjn1tRv2ZNrCFmhZ/1/0/prod/tech/main/t_general
), onda i Sipura 3000 mora podrzavati T.38 i G.711 codece takodjer?
- gafachi.com VOIP provider ovisno od krajnjeg primatelja faxa automatski
bira da li salje fax s T.38 ILI G.711 codecom. Sipura 3000 podrzava oba
codeca i "razumije" ove automatske promjene codeca prije starta transfera?
Razor
pod imenom Linksys a imas i nesto noviji model od 3000 a to je 3102 koji ima
neke nedostatke i nesto prednosti u odnosu na 3000....
"Roki" <ro...@balboa.com> wrote in message
news:evu5k7$dnf$1...@ss408.t-com.hr...
Roki
"Razor" <dreamer...@net.hr> wrote in message
news:evud3j$chn$1...@sunce.iskon.hr...
>U medjuvremenu Sipuru je kupio Linksys tako da se sad ti adapteri prodaju i
>pod imenom Linksys a imas i nesto noviji model od 3000 a to je 3102 koji
>ima neke nedostatke i nesto prednosti u odnosu na 3000....
>
- Ako u Cisco ATA 186 ukljucim standardni fax uredjaj i kako moj VOIP
provider podrzava T.38 i G.711 codece (
http://www.gafachi.com/d/1212995/Sjn1tRv2ZNrCFmhZ/1/0/prod/tech/main/t_general
), onda i Cisco ATA 186 mora podrzavati T.38 i G.711 codece takodjer?
- gafachi.com VOIP provider ovisno od krajnjeg primatelja faxa automatski
bira da li salje fax s T.38 ILI G.711 codecom. Cisco ATA 186 podrzava oba
Roki
http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_qanda_item09186a00800946e1.shtml
Q. What combinations of voice codecs are allowed simultaneously on the ATA
186? Can it support two simultaneous calls with G729A?
A. ATA 186 does not support two ports that use G.729a codec
simultaneously. The G.729 codec can only run on one port at a time. When one
port uses G.729, other port uses G.711. These combinations are allowed on
the ATA 186:
a.. Two simultaneous G.723.1 codecs
b.. Two simultaneous G.711 codecs
c.. One G.723.1 and one G.711 codec
d.. One G.729A and one G.711 codec (G.729A is available on first-come,
first-served basis)
Q. Does the ATA 186 support fax pass-through?
A. The ATA 186 supports fax pass-through. It detects the fax answer
tone, disables silence suppression, and then renegotiates the coder/decoder
(codec) to G.711 u-law or G.711 A-law. It does not support ITU T.38 standard
or Cisco proprietary fax relay.
Refer to Configuring the Cisco ATA for Fax Pass-through mode for more
information on how to configure the Cisco ATA for fax pass-through mode.
Ispada da ne podrzava T.38! Koji ond adapter podrzava oba codeca T.38 i
G.711 a ima ga kod nas kupiti?