with correct R34 resistor value is installed. The D2 LED is blinking at a rate of 2Hz which is correct for this configuration. If you connect an ethernet cable with the board out of the

Hi team, Thanks for your replies so far and thank you for the support. Steve, Ron, over the VPN I can confirm that there are plenty of EP6 drop

value of R34 for the KSZ9031. >> When Makerfabs tests and programs units, they use a Raspberry Pi with short >> ethernet cable and no ethernet switch. That setup does not

value of R34 for the KSZ9021, but the blink rate of the RUN LED is >>>>>> at the slower rate expected for the KSZ9031. (I was wrong about the 1Hz/2Hz >>>>

CHIP AND R34 is correct 68B. >>>>>>>>> think it may need to be reflashed not sure. >>>>>>>>> I will be glad to send it to

Hi Greg, I believe everything has been arranged with Makerfabs for your replacement HL2. The 10RX gateware you installed has a MD5SUM for the

pictures. R34 is correct for the KSZ9021RN, >> although I measure 4.98K on a new board in my lab. The low value is a >> little concerning but I don't think should cause

it is R34 on the >>> bottom side of the board. I think there was a picture with discussion >>> posted once. You can search past threads for R34: >>> >>

Hi Reid, First of all, I want to thank you for all the time and effort you've invested into enhancing and customizing Thetis for the HL2! I'm

Recently I had this idea, to combine two PCBs into one. Specifically Hermes-Lite 2.0 + N2ADR Filter Card. I drew a new PCB named HERMES TRX. [image:

The additional cable should have no effect on the output signal. It does, however, damp the input signal by about 3 dB since the feedback is parallel

> and R34 marking is 688 or 889 according the way you read it, like on >>>> the picture posted by Steve. >>>> I guess I'm fortunate to have got the right

I'm not sure if your PA500 reply was directed towards me. I have no idea what a PA500 is. The PA that I have built is the HL2-MRF101. I built this

Hello Martien, I'm not sure if you're also using the PiHPSDR controller board or connecting the switches directly to the GPIO pins of the RPi.

Hi Mathis/group, I have quickly drawn this in kicad. It didn't even need an extra relay. Please find attached to this email. This discussion also

Hi Group, Attached is a preliminary BOM for beta5. This BOM only includes components that the assembly house will install. There is now a wiki page

Hi All, The BOM generation scripts are working for PDFs. These scripts allow me to create custom BOMs for different build options, different suppliers,

Hello List, Although I'm not quite at the end of my to do list, I want to put the design files out for final review. Here is how you can help: -

Hi List, I've dropped the TX LPFs from the first prototype and am going with a 10x10 cm board at first. It still may take several prototype

Hi Group, The latest schematics are attached to this post as well as on github and on Google Drive . They contain the new power supply. The Cyclone IV