Issue 361 in heekscad: Heekscnc generation toolpath issue.
codesite...@google.com
Owner: ----
Labels: Type-Defect Priority-Medium
New issue 361 by kus.pi...@gmail.com: Heekscnc generation toolpath issue.
http://code.google.com/p/heekscad/issues/detail?id=361
What steps will reproduce the problem?
1. Create circle shape with diameter > 20mm
2. Convert circle to sketch
3. Select created sketch and 3 mm Carbide Slot Cutter
4. Add new milling operation: profile operation
5. For selected profile select tool on side: inside or right.
6. Select Go to generate toolpath
7. Verify toolpath - green line
What is the expected output? What do you see instead?
The generated toolpath radius shall has the same center point as created
circle. And radious of the toolpaht shall be about 1.5mm smaller than
milled circle. Start and End points shall be inside the circle.
In my example Heekscnc has generated toolpath which has different center
point or it isn't circular. See attached image.
What version of the product are you using? On what operating system?
Windows: XP Polish language version
Heelscnc: HeeksCNC 0.18.0
Please provide any additional information below.
I think some meaning may be Windows language version, because I also
installed Heekscnc in the same version on different Windows with English
language version. On the second (English) installation generation toolpath
on the same example seems to be OK.
Attachments:
heeksIssue.JPG 46.3 KB
codesite...@google.com
Comment #1 on issue 361 by lot...@foengarage.de: Heekscnc generation
toolpath issue.
http://code.google.com/p/heekscad/issues/detail?id=361
this is whear
what system are you on and what post processor are you using
this is never seen bevor all works right in version 0.18