Troubleshooting clutch switch

[Manuel Capinha]

Hi all.

Does anyone know if there's a way to diagnose the clutch switch (the one that opens/closes when the the clutch is pressed/depressed) ?

I've searched through all the menus but can't seem to find a way to read this sensor position ?

Regards,

Manuel

[Alun Phillips]

Hi ,if its a disco 3 you should find it in transmissions live data.

________________________________________________________________________
This e-mail has been scanned for all viruses by Star. The
service is powered by MessageLabs. For more information on a proactive
anti-virus service working around the clock, around the globe, visit:
http://www.star.net.uk
________________________________________________________________________

________________________________________________________________________
Disclaimer

This email transmission is confidential and intended solely for the person or organisation to whom it is addressed. If you are not the intended recipient, you must not copy, distribute or disseminate the information, or take any action in reliance of it. Any views expressed in this message are those of the individual sender, except where the sender specifically states them to be the views of Bearmach Ltd. If you have received this message in error, do not open any attachment but please notify the sender (above) deleting this message from your system. Please rely on your own virus check no responsibility is taken by Bearmach Ltd for any damage rising out of any bug or virus infection.
________________________________________________________________________
This e-mail has been scanned for all viruses by Star Internet. The
service is powered by MessageLabs. For more information on a proactive
anti-virus service working around the clock, around the globe, visit:
http://www.star.net.uk
________________________________________________________________________

[Manuel Capinha]

Hi Alun,

I'm sorry for not being clear about my vehicle. It's a 2.5 DSE P38. From your response about the disco 3 I'm guessing I'm out of luck then ?

Regards,

Manuel

[Alun Phillips]

Manual p38 are not common here but that's all you have to do to check them is contiguity test the 2 wires with a ohms tester and check open or closed circuit. hope this helps , Alun