Ydm4109 Factory Reset

[Mellissa Sprock]

Pleaseread this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.

The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.

Use this equipment only for its intended purpose. Follow the disposal instructions.Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

This device and every other certified Z-Wave device can be used together with any other

certified Z-Wave device regardless of brand and origin as long as both are suited for the

same frequency range.If a device supports secure communication it will communicate with other devices

secure as long as this device provides the same or a higher level of security.

Otherwise it will automatically turn into a lower level of security to maintain

backward compatibility.

Please read the user manual before installing the product.In order to include (add) a Z-Wave device to a network it must be in factory default

state. Please make sure to reset the device into factory default. You can do this by

performing an Exclusion operation as described below in the manual. Every Z-Wave

controller is able to perform this operation however it is recommended to use the primary

controller of the previous network to make sure the very device is excluded properly

from this network.

ATTENTION: only authorized technicians under consideration of the country-specific

installation guidelines/norms may do works with mains power. Prior to the assembly of

the product, the voltage network has to be switched off and ensured against re-switching.Inclusion/ExclusionOn factory default the device does not belong to any Z-Wave network. The device needs

to be added to an existing wireless network to communicate with the devices of this network.

This process is called Inclusion.

Devices can also be removed from a network. This process is called Exclusion.

Both processes are initiated by the primary controller of the Z-Wave network. This

controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is

then performed doing a special manual action right on the device.

3a8082e126