Quixx Stone Chip Repair Kit

[Josette Werst]

TheQUIXX Paint Stone Chip Repair Kit developed by paint professionals provides a quick and inexpensive remedy for problems with stone chips in the paint. Click through the pictures step by step and read the different steps.

3. Then glide the enclosed QUIXX rubber squeegee over damaged areas while holding it at a slight angle and pressing it lightly onto the surface, so that squeegee removes excess paint and surface is smooth.

Wait at least 30 minutes.

2. Now you can apply some of the QUIXX lacquer to the squeegee and pull it at a flat angle over the damaged areas, so that the squeegee distributes the lacquer to the damaged areas and it produces a smooth surface.

3. Then glide the enclosed QUIXX rubber squeegee over damaged areas while holding it at a slight angle and pressing it lightly onto the surface, so that squeegee removes excess paint and surface is smooth.

Wait at least 30 minutes.

Stone chips in the paint of bonnet and front bumper cannot be avoided, especially when travelling highways.

The darker the color of the paint the uglier the white stone chips appear.

Deeper stone chips going through the paint job down to the metal can lead to corrosion.

Repainting a whole bonnet is expensive and time consuming.

Thanks to the QUIXX Paint Stone Chip Repair-Kit ugly chips and small spallings in the paint of your car-front will be gone in no time.

This product helps avoiding expensive repairs at car-paint shops and supports retention of value by a simple DIY solution.

Here at QUIXX our motto is clear: Do it. Yourself! Therefore our advice is: Unquestionably do it yourself. Our product is not expensive and it is definitely worth a try. Many users of our products have stated in internet forums that they themselves were surprised at how well they managed even what seemed hopeless cases.

Enthusiastic or destructive journeymen scratch the car paintwork? The same thing can happen at any time if some troublemaker keys your car. This usually causes more serious damage to the paintwork and requires immediate action. Deeper scratches can quickly result in rust and worsening of the original paint damage.

You only have to invest a little time and maybe you could enjoy the repair. And we are sure that you can carry out the repair yourself. Our instruction manuals, written by professionals, explain every step of the repair process.

A fine layer of paint called cataphoretic electrodeposition paint, usually grey in colour, is applied as a dip primer to the bare sheet metal car body, which mainly serves as a protection against rust. This is followed by a layer of primer (filler), which usually appears white, and finally the base or metallic paint, which gives the paint its colour. Finally, a layer of clear coat that is very thick compared to the other layers is sprayed on as a preservative protective layer. How to treat which type of scratches?

Thanks to the very thick finish layer of clear coat, scratches are often not as bad as they look and can be treated very well with our QUIXX special products. If the clear coat is only superficially damaged (micro-scratches, can often be seen on car door handles), light scratches can usually be polished out with a conventional car polish and a little patience.

Slightly deeper scratches will have caused considerably greater damage to the clear coat. If the damage was caused by contact with another car, besides the scratch there will also be remnants of paint form the other car. A conventional car polish is no longer sufficient. In this case we recommend our QUIXX Paint Scratch Remover. Powerful polishing particles not only effectively remove the different coloured paint, but also compensates for the damage sustained by the clear coat.

Stone chips, often found on the bonnet, can be removed quickly and easily with the QUIXX Paint Repair Pen. The fibre head, similar to a felt-tip pen, enables the amount of paint to be properly controlled and precisely applied. It is best to pat the affected area several times and then allow the treated area to dry thoroughly. The smooth finish of the paint surface can then be restored by applying a a good polishing agent (included in the QUIXX Paint Scratch Remover Kit - Polish No. 2).

The QUIXX Windshield Repair Kit provides a reliable and cost-effective alternative to the expense of replacing a windshield. The use of the special application tools with the highly effective, transparent resin is explained in our Step by Step Repair Guide.

1. The repair should be made as soon as possible after the damage has occurred. The windshield should be shielded from direct sunlight during the entire repair process. Before beginning the treatment clean the damaged area of the windshield with a dry paper towel and remove any loose pieces of glass by carefully cleaning the stone chip with the razor blade.

2. Attach base of the applicator over the damaged area so that the opening is directly above the entry point (do not cover any of the cracks with the suction cups) and screw the container tight. Make sure that the rubber seal rests directly on the windshield. This will prevent the resin from leaking out and enable pressure to build up in the container. Now fill the repair resin into the container. Examine the damaged area from the inside of the windshield to see if enough resin has been used.

3. Now turn the pressure plunger clockwise into the repair resin container. Then release the pressure plunger from the container so that the air trapped in it can escape; this is audible. Add some more resin to the container and close it again. Allow the repair resin time to fully penetrate the crack/spalling for approximately 4 to 6 minutes depending on the extent of damage. A hair-dryer can be used to heat the area being repaired; this promotes the flow of the resin. Unscrew the pressure plunger and remove the applicator tool.

4. Apply a drop of the repair resin to the outer area and cover with a curing strip. Place the car [windshield] directly in the sun or use UV light to cause the repair resin to cure completely (takes about 5 to 10 minutes) and then remove the curing strips. After curing, carefully scrape off hard repair resin from all areas except the treated area.

NOTE: To ensure the stability of the windshield, repairs should only be made if the cracking is no greater than 2.5 cm in diameter. The damage must not be less than 10 cm from the outer edge of the windshield. The damaged area must not be directly in the driver's field of vision. A windshield may only be repaired a maximum of 3 times.

Stone chips in a windscreen can quickly become a major problem. Small stones often fall off of trucks travelling in front of your vehicle or are thrown into the air by the tyres of other road users. If they strike a windshield they can cause spalling, known as a bullseye or star-shaped cracks in the windscreen.

But replacing the whole windshield can be very expensive, especially if the vehicle is not comprehensively insured. Also to be considered is the inconvenience of having no car in the time it takes for the repair as well as the cost to hire a replacement vehicle. It therefore makes sense to look at alternatives.

Ideal for this situation is the QUIXX Windshield Repair Kit; fast and easy to use even for persons with no automotive repair experience. The kit is supplied with a Step by Step Guide written by professionals, all necessary tools and a very durable repair resin (Made in Germany) enabling you to repair the damage yourself - permanently!

The Quixx stone chip repair kit makes sure that ugly chips and small spallings in the paint of your car will be gone in no time. This product helps avoid expensive repairs at car-paint shops and supports retention of value by a simple Do It Yourself solution (DIY)

Does your car have stone chip damage? Repair stone chip damage on your car quickly and easily with the help of the sets below. Stone chips on the bonnet or the bumper can lead to rust spots. It is therefore advisable to repair this damage quickly. It is important to thoroughly degrease the places where the paint is gone and to provide new paint so that the surface does not start to rust.

With the help of the kits below, you can easily repair stone chip damage on your car. You can order the original colour for your car from us in a spray can, so that the repair will not be noticed.

Scratch protective lacquer pen. (From very deep and wide scratches, as well as stone impacts) Deep scratches and scrapes, which can even reach the primer. For these critical cases, the QUIXX repair system offers the Paint Repair Pen. It fills deep scratches, protects them and therefore prevents impending corrosion and rust. Features and Benefits: The clear lacquer pen reliably achieves professional quality results. It also repairs and seals very deep scratches and scrapes. Protects against corrosion and oxidation Suitable for all glossy colors and paints (also metallic) The clear lacquer layer fills in scratches and blends very harmoniously with the original paint The pen allows precise operation Very short drying time Application saves repairs and prevents loss of car value. Often, just using special polishes does not completely remove scratches, paint damage, scuffs or stone chips from clear paint. The QUIXX Repair Paint Pen offers an easy, do-it-yourself solution for all paints and bright colors. Fills scratches and damaged areas with authentic clear coat that blends harmoniously with the original paint in a very short period. The special pen tip allows for precise operation and the application of very thin layers. Due to the innovative formula, the paint dries very quickly. The QUIXX Paint Repair Pen permanently seals very deep scratches and scuffs that reach down to the metal. Therefore, it protects against corrosion and oxidation and prevents corrosion damage. Easy and effective application can often avoid costly repairs and achieves the best professional quality results. Tip: By simply applying QUIXX paint scratch remover with a clean and dry cloth, the optical result can be more perfect

3a8082e126