Any way to force GC to pick the cadence from Vector2 power meter instead than from GSC-10 speed/cadence sensor?

[Stefano Mosconi]

Hi,

I have both a Garmin Vector2 Power Meter and a GSC-10 Speed/Cadence sensor installed on the bike.

Since the cadence is calculated by the power meter on the Edge 810 I own I did remove the magnet that would make the GSC-10 calculate it as well.

I now for the first time tried to hook up GC with Ant+ to do a live training session. Both sensors are properly paired but the GC insists on trying to get the cadence from the GSC-10 rather than the power meter. Because of this I get no cadence readings.

Is there any way to force the cadence to be read from the power meter?

Thanks
Stefano

[Claus Assmann]

On Sat, Aug 13, 2016, Stefano Mosconi wrote:

> Is there any way to force the cadence to be read from the power meter?

This has been discussed before, see:

Subject: Train mode: Cadence: Powermeter vs. Speed/Cadence sensor

--
Please don't Cc: me, use only the list for replies.

[Stefano Mosconi]

Thanks Claus,

so for what I understand the capability has not been coded in yet and
if I want GC to read cadence from power sensor I should disable the
speed/cadence.

Right?

Cheers
Stefano

Follow me at
https://medium.com/@stezz/
https://twitter.com/zzste
https://www.linkedin.com/in/stezz
https://www.facebook.com/stefanomosconi.stezz

[Jean Div]

I had the same issue with a Quarq and the GSC10.. it was always either/or.

Recently got one of the new Garmin Speed only units (the one that straps to the rear wheel hub), and this works well - It stays in my trainer wheel and does speed only, and the quarq handles the cadence. Outdoors it pulls speed from GPS. Neat solution.