Thanks,
Steve Nowak
F26083
'78 Royale Center Kitchen
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Am looking for the standard type mirror mounting antennas for the stock original type outside mirrors.
> Anyone have any thoughts.
______________________________________________________________
You are right. since the fad has cooled down, the manufacturers are not producing like they used to. One well known manufacurer near me just closed doors recently.
I saw some antennas on Amazon.com. Mind you they just pick up something to go with a product they are selling at the time, but might be worth a look.
Did you try google? They seem to pull up the item and sometimes sale sites.
Good luck
--
Gatsbys' CRUISER :d
74 GLACIER X, 260
455/APC/4 bagg'r(ver3)
Remflex Manifold gaskets
_______________________________________________
Purchased 08-18-04
_
Run a ground strap to the frame unless it has already been done. My old mirrors were not grounded when I bought it with a set of those. Could not hear a mile away.
Dan
--
Dan & Teri Gregg
///Halon Automatic Fire Extinguishers
There's a few on Ebay. Radio Shack also has them.
--
Tony W.
Kirkland, WA
'78 Kingsley
GMC Cascaders - http://www.gmc-cascaders.com
Ljdavick at comcast.net
Almost any truck stop has them. I've seen them in Flying J, Sapp Bros., and Pilot. Do not bother with the duals. A single one is all that is needed. They do not work very well on our fiberglass front end coaches.
A roof one mounted in the aluminum area would work much better if you can figure out how to run the cable to where ever you are mounting the radio. Use a good quality RX8X coax cable if possible.
--
Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana
The standard mirror mount plates are at most truck stops. However, when you attach them to the mirror mount, consider removing the mirror mount at the body (carefully) and install a wire (ground strap material) attached to a mirror mount bolt (use a circular lug) and drop it down inside the fiberglas front cap. This will help provide an ground plane for the antenna.
No need to use two whips, managing the proper phasing of loaded 1/4 antennas with the coax feed lines and the distance between the two mounting locations (pretty much pre-set)would be a headache.
As always, your mileage may vary.
Tom Phipps,
KA4CSG
75 GMC Ex-Avion
Monitoring 146.52 in the GMC.
Ken Burton wrote:
> Almost any truck stop has them. I've seen them in Flying J, Sapp Bros., and Pilot. Do not bother with the duals. A single one is all that is needed. They do not work very well on our fiberglass front end coaches.
>
> A roof one mounted in the aluminum area would work much better if you can figure out how to run the cable to where ever you are mounting the radio. Use a good quality RX8X coax cable if possible.
>