how to achieve the slope

[glbmail.com]

----- Forwarded Message ----
From: siva <siva...@yahoo.com>
To: Piping...@yahoogroups.com
Sent: Thu, 3 March, 2011 11:48:48 AM
Subject: [PipingDesign] how to achieve the slope

 

slope for steam lines are necessary and the same is indicated in degree or 1:125 e.g.in the case of thick pipes like mainsteam pipe for the utility boilers,how the required slope is achieved in the field?
is it necessary to indicate in the drawing different angles instead of all bends as 90 degreees or 89.5,90.5 etc?i understand for thin pipes in the field the erection group adjust the weld gap to achieve the required slope.can the same procedure accepted for thick pipes also?will it not affect the weld gap?
thanks

__._,_.___

Reply to sender | Reply to group | Reply via web post | Start a New Topic

Messages in this topic (1)

Recent Activity:

• New Members 2

Visit Your Group

=========================================
PipingOffice - Excel Spreadsheets for Piping Calculations
http://www.pipingoffice.us/
=========================================
Main site: http://www.pipingdesign.com

MARKETPLACE

Get great advice about dogs and cats. Visit the Dog & Cat Answers Center.

---

Stay on top of your group activity without leaving the page you're on - Get the Yahoo! Toolbar now.

Switch to: Text-Only, Daily Digest • Unsubscribe • Terms of Use

.

__,_._,___