Issue with booting from configuration memory devices in VCU118 FPGA Installation

[Manchem Chandana Sai Sri ee19b093]

Hello Sagar,

  I tried booting from configuration memory device on VCU118 board multiple times but in vain. Programming of configuration memory devices was successful but the booting is not being done properly. The DONE pin is going HIGH very quickly after cold booting the FPGA, which is indicating that the booting is not being done properly as the booting should atleast take around 15 minutes for 2 mcs files of size 48 MB each.

Anyone has any solution for this problem?? I am stuck with this problem for a while now.

This is how the output looks like when I try booting from configuration memory device

boot_hw_device  [lindex [get_hw_devices xcvu9p_0] 0]
INFO: [Labtoolstcl 44-664] Will wait up to 180 seconds for booting to complete.
INFO: [Labtools 27-32] Done pin status: HIGH
refresh_hw_device [lindex [get_hw_devices xcvu9p_0] 0]
INFO: [Labtools 27-1434] Device xcvu9p (JTAG device index = 0) is programmed with a design that has no supported debug core(s) in it.

Thank you

Sincerely

Chandana Manchem

[Manchem Chandana Sai Sri ee19b093]

Hello everyone,

The error has been resolved when I removed the jtag connection, rebooted the entire system( not just switching off the fpga).

Thank you

Sincerely

Chandana Manchem