Migration fault

[Przemek Nagański]

HI everybody!

I want migrate to 1.0.0 firmware (I have AtMega168 FIGnition). When I use avrdude i got this message:

avrdude: warning: cannot set sck period. please check for usbasp firmware update.

avrdude: AVR device initialized and ready to accept instructions

Reading | ################################################## | 100% 0.00s

avrdude: Device signature = 0x1e9406

avrdude: reading input file "MigratorPAL.hex"

avrdude: input file MigratorPAL.hex auto detected as Intel Hex

avrdude: ERROR: address 0x0210 out of range at line 33 of MigratorPAL.hex

avrdude: read from file 'MigratorPAL.hex' failed

avrdude done.  Thank you.

Any idea?

[Julian Skidmore]

Hello Przemek,

The address 0x0210 is certainly in range for an AtMega168 FIGnition, it's merely 528bytes into the flash!

So, something else must have gone wrong. What was your command line?

-cheers from Julz

--
You received this message because you are subscribed to the Google Groups "FIGnition" group.
To unsubscribe from this group and stop receiving emails from it, send an email to fignition+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

--

                             
                  The DIY 8-bit computer from nichemachines™

[Carl Attrill]

Have you tried to write to eeprom? , there is a subtle difference in the command line.

[Julian Skidmore]

Hi Carl,

Good point!

-cheers from Julz