[f-AA] Leading edge vacum forming
1 view
Skip to first unread message
Ian Harvie
May 31, 2011, 6:44:43 PM5/31/11
to aer...@westmont.edu
Rafael, I did my leading edges using two pieces of 4" X 4" pine screwed
together. Used a length of 2" water pipe to press the metal into the groove.
Takes two people really, one each end of the pipe to press it in to the
gap. I marked the bottom of the bend with a marking pen taking the
measurement from the old sheets.
together. Used a length of 2" water pipe to press the metal into the groove.
Takes two people really, one each end of the pipe to press it in to the
gap. I marked the bottom of the bend with a marking pen taking the
measurement from the old sheets.
Ian
On 1/06/2011 5:54 AM, Rafael wrote:
> Found this on the net, sounds eady
>
>
> _______________________________________________
> Aeronca mailing list
> Aer...@westmont.edu
> http://mail.westmont.edu/mailman/listinfo/aeronca
Reply all
Reply to author
Forward
0 new messages