Printed parts

[jason carlisle]

Do you guys know if Mark has, or will, release the files for the printed parts. The printed pieces in my kits are very poor quality. I can tell that eventually I'm going to need to reprint my own parts, especially the part with the Idler wheel, it split just while I was trying to clean the hole of the excess plastic. Unfortunately I didnt thing to reverse engineer/recreate the piece with the LEDs and idler wheel until I had glued in the pieces in place.

[Herb Winters]

I don't know, But I hope so because the printed part that hold the ssr, terminal Block and PCB was broken in shipping I used crazy glue to put it together but I'm sure I would like to make a new one of them.

also I would like to make a modified version of the Pellet feeding tube with the detection. I need the leds mounted higher up on the tube.

[Herb Winters]

here is a link to a left side bracket I designed for the ExtrusionBot it is much stronger and puts the PCB beside the SSR so that all connections can be worked on from the side of the unit. also hold the terminal strip.

https://www.youmagine.com/designs/herb-winters



NOTE: to use this bracket you need to place the Solid state Relay,PCB and Terminal on the left side and the power supply on the Right this layout works much better but requires a little more effort.
Please take a look at this thread: https://groups.google.com/forum/#!topic/extrusionbot/4qZp47ddcYU