Uscutter Sc2 Software

0 views

Skip to first unread message

In Libman

unread,

Aug 3, 2024, 5:15:19 PM8/3/24

to evertabsu

Got my cutter yesterday, assembled it today and connected it to my laptop at first via USB, went to Vinyl Spooler in VM to setup the connection. After hitting detect and it goes to step 1 and I turn off the cutter it automatically goes to step 2, after turning it back on VM doesn't detect it. Tried it in different USB ports on the laptop, same issue. Plugged it in my desktop, same issue. Any suggestions? Am I doing something wrong? Tried it with 2 different cables, checking to see if it was maybe that.

Did you download the driver, and install for the USB connection? USB on a value cutter is not True USB like higher end cutters. After you download the driver, reboot your computer. It creates a com port number in your computer device manager. The com port numbers have to match in your computer device manager as well as your software. Vinyl cutters are not plug and play.

In most cases, all needed PC drivers will be preloaded in VinylMaster. If you need to download and install drivers for the USB connection to work properly go to www.uscuttersupport.com and select the driver that supports your Windows version.

After you sort out this minor issue, please provide us with some videos and feedback on how you are liking the LP3 ---- it ticks off a lot of boxes for an introductory level cutter, with features like a stand with media holder included; superior tracking roller mechanisms; quieter operation; and more.

How did you set your blade depth? Too many incorrect instructions out there. Never use a credit card width or post it notes to set blade depth. They are incorrect and about 10 times too much blade exposed out of the blade holder.

All I did was everything Mz Skeeter suggested. Installed the Laser Point II driver, even though I have the LPIII it still worked. After restart, went to device manager and found the Port #, went into VM and manually chose that com port and it worked!

I forgot to mention that I also did that after using the card to set the depth, did a few tests before loading it. I've seen so many people saying they messed up their cutting strip, I was beyond paranoid doing my first cut

And people stop ready the instructions. The ones I read that mention the credit card say it's a starting point and then go on to describe basically Skeeter's method for setting blade depth. Although it used paper rather than vinyl.