Eorm 3.2 with Amplitube EP mode effects leds

24 views
Skip to first unread message

James Williams

unread,
Apr 29, 2025, 12:28:35 AMApr 29
to EurekaSound! Forum
Hi! So Ive installed and been setting up ePROM 3.2 with amplitube using an mbox2. All is well aprt from one thing that I don't know if I have to put up with it or if I can configure a solution. This one thing is that in EP mode when I change rpesets my effects buttons (1-5) always blink and I have to hit them once to activate then once again to turn the pedal on. I just want to change to a preset then hit the effect button once to turn on effect.... change to another preset then hit the effect on by just hitting the effect button once again. is this possible or do I have to change preset then hit every different effect button to activate it then again to turn pedal on everytime I change presets in EP mode?

Looking forward to your reply

James Williams

unread,
Apr 29, 2025, 12:31:13 AMApr 29
to EurekaSound! Forum
Title should be Eprom sorry.

Dave

unread,
May 2, 2025, 5:14:20 PMMay 2
to EurekaSound! Forum
Yes, in effect units without effect state probing, when a preset is changed, the effects pedals go into the "unknown state", which is signified by flashing. When you press a pedal with a flashing LED, a CC#x:v=127 is sent, which should be "effect on". Potentially that effects is already on, in which case there will be no sound change. 
Reply all
Reply to author
Forward
0 new messages