EurekaSound! Forum

I get a +118.8. on screen and nothing else

Cancel. I set it correctly On Monday, November 4, 2024 at 5:10:16 PM UTC-5 David Graham wrote: If you

Yes, you can do a factory reset: https://www.eurekasound.com/eurekaprom/misc#h.p_ID_407 On Tuesday,

You'll want to program the MIDI # - to - Revalver setup as described on this page: https://

Here's an article for setting up a MIDI controller for Revalver: https://support.headrushfx.com/

Generally USB-to-MIDI devices either come with their own specific driver, or they use a generic one

Unfortunately Shapeways Inc, who printed our pickup mounts, went bankrupt. And there isn't a

Correct On Wed, Aug 14, 2024, 1:21 PM Dave <da...@eurekasound.com> wrote: Sorry you're

It sounds to me that you have it round the wrong way. Do you want the Pedal Board to send a MIDI

Yes, you can put the original Beringer PROM back in to get the original functionality. On Friday,

Hi Justin, Your best bet would be to assign the pedal to be type "toggle" - each press

Yes, I was able to setup a configuration in the EP mode to control the MP1 and the G Major. my

Please make sure that you enter the preset you want to save using the EurekaPROM-enabled FCB1010 only

Igor, Ah, yes, a multi-device setup. The MIDI cabling for a multi-device setup looks like this:

You can leave the preceding CC# with value 0 for the POD HD Pro X. Then I believe you can use the

Hi Ron, For me, I put my EurekaSound equipped FCB1010 in IO mode and then use Bome MIDI Translator

I just picked up a Eureka 3.2 FCB1010, with the hopes that I can use it for controlling a couple of

Yes - what you're describing is EP mode. On Tuesday, May 14, 2024 at 11:33:25 AM UTC-4 bobbyw...@

Hey Phill, Is the EurekaPROM-enabled FCB1010 in the 11 configuration? (When you power it on, you'

After familiarizing yourself with the elements of Bome midi translator pro (options - rules and

If you'd like to be able to send MIDI to the G Major from your computer and your FCB1010, then I

If you'd like to be able to send MIDI to the M13 from your computer and your FCB1010, then I

Hello I did this connetion Computer MIDI Out -> FCB1010 MIDI In, FCB1010 MIDI Out -> G-Major

That makes sense, it's good to have a definitive answer on this longstanding topic. I do think I

Ah, you found a misprint on the site! You are correct, there is no MIDI pass thru in the IO

What's not working about them? What configuration do you have it in? On Friday, March 1, 2024 at

Hey Nik, Glad you're digging the pedal! There isn't a way to have multiple banks of FP. BUT,

That stinks! Never heard of something like that. So, after reseating the EurekaPROM, it still acted

Hi Dave, I ended up re-programming the CC for each switch. MIDI monitor showed CC changes initially,

OK, thanks Dave. On Wednesday, December 6, 2023 at 9:24:34 PM UTC-5 Dave wrote: Hi Jason - thanks for