final project

[Kris Pister]

1) get checked off by any TA or me, before 3:30 thursday. All TAs will
be holding section and office hours in the lab this week.
2) email me your report (powerpoint) by 3:30 pm thursday
3) bring a printed copy to class thursday
4) bring three or four pages from your powerpoint deck to show in class
thursday.
I'll walk around the room and ask each team to give me 2 minutes or so
of explanation of what they did. Both partners need to be able to
explain something about the design. Note that 60 seconds isn't very
long, so think about what you want to say beforehand!

The report should include:
* goals
* block diagram
* schematics (with all node voltages and "leg" or "string" currents labeled)
* hand analysis - make it clear *what* you are analyzing
* spice analysis - make it clear *what* you are simulating
* measured results - make it clear *what* you measured
* comparison of hand, spice, and measured data
* any design tricks or cleverness that you're proud of

Your audience is your fellow students, so make sure that your
descriptions and explanations are clear to someone with that knowledge.
In particular, do NOT just put spice plots in your report without being
*explicit* about what the simulation is! Detailed captions are a really
good idea: "Transient simulation of the receiver from schematic 3A with
a 1mV 1kHz voltage source in place of the microphone"

ksjp