Change Gcode save as extension to .NC

[Senior Elf]

Hi i am running a 3018 Pro machine and if i run the output -Gcode through Candle i have no problems, however if i save to the controller and run off-line the .NGC extension is not recognised.

how can i save as .NC or .TAP? 

Many thanks

neil

[Christian Kohlöffel]

You just need to edit the postprocessor configuration.

Check the Wiki at:

https://sourceforge.net/p/dxf2gcode/wiki/Postprocessor%20Configuration/#general

 

Note: You can also use the configuration window to do it …

 

Regards

Christian

--
--
You received this message because you subscribed to the Google
Groups-group "dxf2gcode-users".
To post a message, send mail to dxf2gco...@googlegroups.com
To unsubscribe, send mail to dxf2gcode-use...@googlegroups.com
See http://groups.google.de/group/dxf2gcode-users?hl=en for more options
and the dxf2gcode project page at http://code.google.com/p/dxf2gcode/
---
You received this message because you are subscribed to the Google Groups "dxf2gcode-users" group.
To unsubscribe from this group and stop receiving emails from it, send an email to dxf2gcode-use...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/dxf2gcode-users/b42abf15-bf97-4dec-9b65-577bec4f0b48n%40googlegroups.com.