Multiple faults and corrective actions

[Fabio Caponetti]

Hi,

we in my group have a little concern about the corrective actions in case of multiple faults in the industrial track.

If a single fault is acting, the corrective action is sent at the same timestamp in where the detection - hopefully - is made. What about about multiple faults? We can see from the example that the corrective actions are put all in the first row of the detection corresponding to the first acting faults, but the other faults are showing themselfs afterwards. The question is, to which time instant the sequence of actions is referring to?

Thanks for the help!!

[Scott Poll]

The correctness of the action(s) is assessed at the end of the
scenario. So, if there are multiple faults, the corrective action(s)
should correspond to the state when all faults are present. What we
recommended last year is to send diagnosis messages early and often
(i.e., after each suspected fault is detected) but hold off on sending
the corrective action/command(s) until after 3 minutes and 30 seconds
into the scenario (no faults will be injected in the last 30 seconds
of the scenario).

On Jul 27, 11:48 pm, Fabio Caponetti <fabio.capone...@gmail.com>
wrote: