total _pulse reset

[Shane mc crossan]

Hello,

I was lookng to do a total-pulse reset on an SW3L-LB-006 water flow sensor device. I have tried to do it via downlink but it does not seem to be working. i have used the command A6000001 to try and set count to 1 but does nothing and does not get a response. using the AT commands over bluetooth with the command AT+ SETCNT =0 does work.

Any help with this would be appreciated because i would rather do this via downlink than bluetooth.

Regards

Shane

[Mengting]

Hi, Shane,

Configuring nodes directly with AT commands is immediate.

If we use downlink commands to configure the node, the downlink commands sent through the server can only be issued and implemented after the node uplinks.

When you set the downlink command 0xA6000001 on the server, you can wait for the node TDC to send a packet or manually press the key to send a packet.

The node will uplink the uncleared count, but the downlink instruction 0xA6000001 will take effect after the node uplink, that is, the node will start counting from 1 after the uplink.

Best Regards
Ting
Technical Support Engineer

 

Dragino Technology Co., Limited

Room 202, Block B, BCT Incubation Bases (BaoChengTai),  No.8 CaiYunRoad

LongCheng Street, LongGang District ; Shenzhen 518101,China

Direct: +86 755 86610829 |Fax: +86 755 86647123

------------------------------------------------------------------

发件人：Shane mc crossan <shanemc...@gmail.com>

发送时间：2024年7月5日(星期五) 22:43

收件人："Dragino-user"<dragin...@googlegroups.com>

主　题：total _pulse reset

--
You received this message because you are subscribed to the Google Groups "Dragino-user" group.
To unsubscribe from this group and stop receiving emails from it, send an email to dragino-user...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/dragino-user/b04e9438-a9fe-436a-a2e2-08f962e25a53n%40googlegroups.com.