FreeDV 1.8.0 20220330 build available

[Mooneer Salem]

Hi all,

I have a new build of 1.8.0 available with the following changes:

1. Resolves low quality TX audio issue when Speex is enabled.

2. An experimental "freedv" package that uses PulseAudio has been generated to go along with the default PortAudio one. This is named "freedv-pulseaudio". (Note: only one freedv package can be installed at a time.)

You can download these builds over at https://www.dropbox.com/sh/06i92xteh20ln1b/AABIgpGb0ddmh6qne1qDdMzva?dl=0. As always, let me know if you run into any issues.

Thanks,

-Mooneer K6AQ

[Keith Prosser]

hi Mooneer

downloaded ok and ran it did not crash I do more tests later today keep up the good work.

Keith GW8TRO

--
You received this message because you are subscribed to the Google Groups "digitalvoice" group.
To unsubscribe from this group and stop receiving emails from it, send an email to digitalvoice...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/digitalvoice/CAAzDfxPbj0eCxt8UOOJOjp9di3zRiYArS1yodgf_jDx9%3DFz-Pw%40mail.gmail.com.

[Keith Prosser]

Hi Mooneer,

did few test v sdr and had a comment off GW3OAJ saying that the audio is a lot better in the 4 old modes.

what I found was when I tried 2020 I would have to reboot the prog to get it to work and after the test I would have to reboot again.and the audio was very poor so going to leave 2020 well alone for now did not use it before but 2020 audio was better in early prog. 

the new 1.8 was on the two pc one win10 and the other win11 Cess did not say what prog or the computer he was running as he had to get away to take a phone call.

Keith GW8TRO

On 30/03/2022 08:16:39, Mooneer Salem <moo...@gmail.com> wrote:

--