How to copy the U11, U22 and U33 values (refined)

[Roshan Jayathilaka]

Hi All,

I am considering some cement samples, and I have started the refining (as per previous studies done on similar samples) from a higher r-value range in PDFgui, considering only crystalline phases in cement (as the higher r-value range covers most of the crystalline phases).

After refining the U11, U22, and U33 values in a higher r range, I need to copy the refined U11 to U33 values of each phase and paste them as the starting values in the lower r range. In the lower r-range, I am introducing some amorphous phases and will refine them, keeping the parameters of crystalline phases constant.

However, I am struggling to copy the refined U11 to U33 from the "results" tab of the refined phases. Right click--> copy--> paste and Ctrl+C--> Ctrl+v are not working inside the result tab. The configure tab only shows the original (initial) parameters of each phase, and the same in the global result file. 

Your help regarding this is much appreciated. 

P:S: I can enter the values manually; however, it will consume lots of time.

Thank you,

Roshan