Designjet 1055CM error 0B0006

[knise...@gmail.com]

I have a designjet 1055cm that I am working on.  Looks like I bent the trailing cable ends and it gave me a 0B0006 error code (I was replacing a belt).  This is an older version 1055cm where there is no detachable glass fuse.  Im going to cross my fingers and hope that I didnt burn the fuse up and hope its just the trailing cable.  I am going to replace the trailing cable next couple days or so.

But just in case, do you happen to sell the fuse for these that I can solder on?  Where is it located? Not finding much online and my client needs it back asap.

Thanks  again

[Tom Bush]

You are correct. The bent trailing cable may have caused the 'error code of death' to your emod. I would attempt replacing the trailing cable first. If the error continues, the emod will need be replaced. There is no way to replace the soldered fuse. The board will nee replaced.

Replacement parts for the HP Deisngjet 1055cm printer can be found here:

http://designjetpartsfast.com/collections/designjet-1000-series