Mach3 Software !!TOP!! Download
HALEY SCHANDELMIER
hello excuse me I have a problem that I do not understand when I pass the gcode generated by EASEL on mach3 nothing happens no movement nothing I do not know why and especially how to solve the problem
(Looking through the forums, it looks like I may need to enable "machine configuration", as in through mach3mill.cps, the code itself?)
A post where I am wondering if the attached M4x.cps file is something I can use, going to check it out:
-processors/need-help-modifying-mach3mill-post-for-use-with-trunni...
I have the same problem. Specifically, I cannot access the 4th axis using the Autodesk post processor for Mach3. I've tried to tweak the .cps file myself without success. I've also tried Daniel_Lyall's "mach3mill with-axis.cps, also without success. I keep getting the message "Direction is not supported for machine configuration."
I use mach3 with my 30 X 30 Longmill. So far I have had no problem.
I am using RnR controller, but had to do extensive research initially for the settings.
I am not new to mach3, but have been using it for about 8 years, which is the reason I went this route . The RnR controller is USB and 4-axis (does not use parallel port and are the ones I am using . There are other USB controller cards available. Some less spendy and some more, some 3-axis and some more.