need help in charger 2TB

[datarecovery 50]

modified usb to sata on original pcb by wiring its ok read SA region ,tracks all ok heads test ok 

no bad modules but all data is encrypted 

hex data in sector 0 on original USB800067 is typical same on native sata pcb 800065

i removed 4 capacitors and oscillator 

i hope if there solution or an idea  why 

[RecuperoDati299]

Please 

Write here the full story

P.S. just for my curiosity, where are you based?

Anyway 

If the drive stays encrypted with its original board, somebody could have swapped it

Read the ROM and compare the last 4 couples of the WWN

this will tell if the board is the original one of that drive

If it is original, check the security tab, switch the encryption 

Also Write here the full MDL of this charger including MFD

Kind regards

Robert

CTO

RD299

Ottieni BlueMail per cellulari

--
Data Recovery Certification Group / for issue with google group please email sc...@myharddrivedied.com
---
You received this message because you are subscribed to the Google Groups "DataRecoveryCertification" group.
To unsubscribe from this group and stop receiving emails from it, send an email to datarecoverycertif...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/datarecoverycertification/6bf0a175-0e8e-4648-9895-11626c93632dn%40googlegroups.com.

[RecuperoDati299]

P.S. forgot

You said you soldered the wires on the board

Make them really-really short

Ottieni BlueMail per cellulari

Il giorno 18 dicembre 2025, alle ore 06:25, datarecovery 50 <datarecovery...@googlegroups.com> ha scritto:

--

[datarecovery 50]

WDC WD20SDRW-11VUUS1 full model   2021

WWN is typical in rom  and its original board 

security switch for enable or disable SED ? 

default is enabled in this version even if disable sectors changes to different hex data 

the lenght of wire only 5cm only and worked with many many cases with same wire 

its 3rd time to meet this problem in my cases

full story ok 

came with bad rom modules auto changed to 0000 and i repaired them by 2nd backup of rom modules and its ok detected and accessed to SA without problem  in my  sata 8000065

read region copy 0 and may be i did mistake here to rewrite region back iam not sure 

then convert original usb to sata and add to HDA to start in recovery