Jumpstart fails

[explor]

Hi Gurus,
I'm trying jumpstart T2K server and it fails with following error:

{0} ok boot /pci@780/pci@0/pci@1/network@0 -s
Boot device: /pci@780/pci@0/pci@1/network@0 File and args: -s
Manual Configuration: Host IP, boot server and filename must be
specified
ERROR: boot-read fail

I checked the show-nets and watch-nets to make sure the NIC is
connected and has the right MAC address defined in the jumpstart
server.

{0} ok cd /pci@780/pci@0/pci@1/network@0
{0} ok .properties
local-mac-address 00 14 4f 82 41 46
mac-addresses 00 14 4f 82 41 46

grep t2k1 /etc/ethers
00:14:4f:82:41:46 t2k1.domain.com

Jumpstart server is fine.

I did goolging but couldn't find the answer. Any Help is greatly
appreciated.
TIA

[Thomas Maier-Komor]

explor schrieb:

what is in /etc/bootparams? Did you setup dhcp?

[djr]

This is a shot in the dark, but who knows.

My company purchased 2 T5120's a few months ago, long story short,
BOTH servers had faulty power distribution units (these were brand
spankin' new from Sun). Once Sun replaced the parts...BAMMM, I was
able to jumpstart as I would of expected.

I don't know if this is a new server you are talking about, the T5120
is some what based off the T2000, so I just thought I would share.

I would get the same error you get when I try to jumpstart my T5120's

If it does not help you, I'm sure someone else with a T5120 will have
the same issue as I did.

-DR