Request information for Maxitor 7080AT, 7213AT

[Mike Chang]

Hi,

I recently bought two used maxitor drives without documents. I was
wondering if anyone can find the parameters for Maxitor 7080AT and
7212AT (cylinder,head,sector number,etc). I also would like know
what the jumper settings are for master,slave and single drive
configurations. Thanks much.

Happy holiday.

Mike
--
The opinions expressed are not necessarily those of the University of
North Carolina at Chapel Hill, the Campus Office for Information
Technology, or the Experimental Bulletin Board Service.
internet: laUNChpad.unc.edu or 152.2.22.80

[Mike Chang]

>I recently bought two used maxitor drives without documents. I was
>wondering if anyone can find the parameters for Maxitor 7080AT and
>7212AT (cylinder,head,sector number,etc). I also would like know

------

>what the jumper settings are for master,slave and single drive
>configurations. Thanks much.
>
>Happy holiday.

Oops, I meant 7213AT drive.

--Mike

[Martin Tichy]

Just to be a little more detailed on what I posted earlier.
I'm looking for a high end 17" monitor that will be able to do
1280 x 1024 x 256 at 74Hz NI, have front panel controls, the
ability to use the full screen, degaussing, digital presets,
and it must look bright and sharp.

So far I hear the NEC 5fg is the way to go. For it's cost
however I can get some 20" monitors. So what is the best
monitor I can get for $1800 Canadian or less?

Other CRTs I'm considering right now are the MAG 17f,
Viewsonic 7, and the Nanao 560ti. Can I get some specs on any
of the monitors mentioned or anything else in that price range?

Merry Christmas!

[Ken Thomson]

In article <1992Dec23.0...@samba.oit.unc.edu> Mike....@launchpad.unc.edu (Mike Chang) writes:

>>I recently bought two used maxitor drives without documents. I was
>>wondering if anyone can find the parameters for Maxitor 7080AT and
>>7212AT (cylinder,head,sector number,etc). I also would like know
> ------
>>what the jumper settings are for master,slave and single drive
>>configurations. Thanks much.
>>
>>Happy holiday.
>
>Oops, I meant 7213AT drive.

Maxtor 7213AT
=============

Master/Slave J20 J19 J18 J17

Only drive in system J J

Master drive in dual system J O

Slave drive in dual system O J

(where J=jumpered, O=open)

Common AT BIOS Parameters :-

CYL HEADS SPT MBYTES TYPE
Maxtor 7213AT 683 16 38 203 47

WPC, and Landing Zone entries do not need to be specified. The IDE
interface will ignore an set values for these 2 fields.

Hope that will help you.
--
Ken Thomson. (ktho...@extro.ucc.su.OZ.AU) #include "std_disclaimer"

"To err is human, but to really &^$% things up takes a computer."
--