SLIP communications from W95 dialup to AS/400 async

[Kim Mølgaard]

Having configured the AS/400 to accept incoming calls on an async line, I am
baffled to what to do next. I have tried to configure my dial-up in win95 to
connect to the AS/400, and i have come so far to use the terminal window
after connect. I here type my userid and password and after pressing enter e
couple of times i get my IP adresses for the AS/400 and the remote. But what
next if i press F7 then i exit the terminal window and returns to the
verifying userid and password thing in W95, after a while i get a message
that there was no protocols matching the ones specified in the dialup
configuration.
What am i doing wrong here !
All suggestions are very welcome

Regards
Kim Moelgaard, EXCEL DATA A/S

[Ralph Day]

Make sure your dial-up networking connection only has IP as a protocol
and the box "log in to network" is *not* checked.

"Kim Mølgaard" <k...@exceldata.com> wrote:

Ralph Day
Systems Development Manager
Recreational Equipment, Inc.
Quality Outdoor Gear and Clothing Since 1938
http://www.rei.com
Work: rd...@rei.com
Personal: ralp...@blarg.net
Opinions expressed are my own....

[Kim Mølgaard]

I did this from the beginning, so it's not that, any other suggestions are
welcome.

Ralph Day skrev i meddelelsen <349fc0e8...@news.blarg.net>...

[Jimmy W. Parker]

Make sure that you are using CSLIP for Unix connections, bring up
terminal window before and after are not checked, TCP/IP under server
has the correct address and log into network IS checked. I use this to
a number of accounts and it works perfectly and logs on completely
after clicking connect on the DUN screen.
--
Jim

Jimmy W. Parker
jwpa...@cjnetworks.com

Kim Mølgaard <k...@exceldata.com> wrote in article
<687ipk$jdd$1...@news1.inet.tele.dk>...