Communicate with xPC without Simulink Coder?

[J.G.]

Hello,

Assume I have build a Simulink model to an xPC target dlm file using an installation of Matlab including Simulink, Matlab Coder, Simulink Coder and the xPC target toolbox.
Now, my question is: is it possible to use another PC where only Matlab and Simulink and perhaps xPC target are installed (but not the two coders!) to act as a host PC in a host - target setup where the target is an xPC machine.
So in summary, can I use Matlab commands like "tg = xpc()", "tg.load", "tg.start" etc. in an environment without Matlab Coder and Simulink Coder when I already have a prebuild dlm file.

Thanks in advance!

Regards

[Thomas Marullo]

Yes, as long as you have xPC Target installed on the Host machine, you are able to call 'tg = xpc' and get the xPC Target environment and load the DLM model. The model has to be compiled for the correct xPC Target version.

"J.G." wrote in message <khpqgi$8oc$1...@newscl01ah.mathworks.com>...

[J.G.]

Allright, Thank you very much!

"Thomas Marullo" <tm...@lehigh.edu> wrote in message <khvfgg$p76$1...@newscl01ah.mathworks.com>...