hardwired ethernet chip

[yogi]

hello,
anyone know about how to put the source hardware addresse and ip
addresse in new wiznet nm7010b+ module . i mean what could be the
addresse.

[David Schwartz]

What do you have the NM7010B+ connected to? If it's to a device that
has a port specifically for an NM7010B+, then follow the instructions
that came with that device.

If you went out and bought a new videocard and you asked how to
interface to it, I'd point you the PCI-e specification. But you may
just need to plug it into your computer.

If you really are trying to do the hardware interfacing yourself, you
need the datasheet for the W3150A+. (And you need the necessary skills
to fully understand the datasheet.) It's pretty hard to use an NM7010B
+ without it.

The SHAR (source hardware address) goes in registers 0x09 through
0x08. The SIPR (source IP register) holds the IP address, registers
0x0F through 0x12.

It's not clear what your asking. Is your question:

1) What should the source addresses be?

2) I know what the source addresses should be, but what values go in
what registers?

3) How do a I set a register to a particular value?

Where in the process are you having trouble exactly? You may be
missing some of the basic skills needed to do what you're doing.

DS