Broadcom tg3 parameter for RH Linux

[YesBalala]

I am looking for the parameter to be place in modules.conf to setup
this nic as 100 Full, and disable auto-neg, but seems cannot find it
anywhere. Is there anyone know what's the paramter to do so?

I am running RH Linx 8 on Dell PowerEdge 2650.

Thanks.

Bosco

--
Due to heavy spamming, I was forced to use an invalid reply address.
Do NOT reply to this posting via email directly.

[Dances With Crows]

["Followup-To:" header set to comp.os.linux.hardware.]

On Thu, 26 Feb 2004 20:32:56 GMT, YesBalala staggered into the Black Sun
and said:
> I am looking for the parameter to be place in modules.conf to setup
> this nic as 100 Full, and disable auto-neg, but seems cannot find it
> anywhere. Is there anyone know what's the paramter to do so?
> I am running RH Linx 8 on Dell PowerEdge 2650.

The tg3 module as shipped with vanilla kernel 2.4.24 only has one
parameter, "tg3_debug", which increases the number of debugging messages
the module prints. I think you want to use "mii-tool -F 100baseTx-FD
eth0" in /etc/init.d/boot.local or Redhat's equivalent
(/etc/rc.d/rc.local ?)

--
Matt G|There is no Darkness in Eternity/But only Light too dim for us to see
Brainbench MVP for Linux Admin / mail: TRAP + SPAN don't belong
http://www.brainbench.com / Hire me!
-----------------------------/ http://crow202.dyndns.org/~mhgraham/resume