Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss
pass cell feed thru switch fabric
0 views
Skip to first unread message
Evan Kalbach
Jan 1, 2010, 7:50:57 AM1/1/10
to
Can I simply pass traffic from a cell tower thru a Cisco switch to
another switch and then exit to whatver card the cell folks are using.
The feed they provide will be from a similare card on the remote side
was well. These cards take the cell stuff and basically convert it from
copper to fiber.
My issue is shortage of fiber for 1 site and a broken path to the far
side on the other. I do have a point in the middle where they all meet
and I do have a path to the far end. My only issue is to do this I must
pass this through my Cisco hardware. In my eyes it should be simple
media conversion but I am only guessing.
Thanks
another switch and then exit to whatver card the cell folks are using.
The feed they provide will be from a similare card on the remote side
was well. These cards take the cell stuff and basically convert it from
copper to fiber.
My issue is shortage of fiber for 1 site and a broken path to the far
side on the other. I do have a point in the middle where they all meet
and I do have a path to the far end. My only issue is to do this I must
pass this through my Cisco hardware. In my eyes it should be simple
media conversion but I am only guessing.
Thanks
Phil Harrison
Jan 4, 2010, 12:45:59 PM1/4/10
to
On 2010-01-01 13:50:57 +0100, NOSPAM.Ev...@nickandre.com (Evan
Kalbach) said:
Kalbach) said:
What sort of encapsulation does this traffic use? I'm guessing it's not
Ethernet, in which case you're likely out of luck.
Can you tackle this at L1 and use a simple mating sleeve, or do I
misunderstand the problem?
/Phil
0 new messages